Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
What two devices are responsible for converting the data from the WAN service provider into a form acceptable by the router? (Choose two).
the serial port of the router
a modem
a switch
the ethernet port of the router
a CSU/DSU device
a DTE device
ccna exploration 2 chapter 2 Exam Question And Answers
What two devices are responsible for converting the data from the WAN service provider into a form acceptable by the router? (Choose two).
Newer Post
Older Post
Home
Popular Posts
RIPv2 is the configured routing protocol on the routers in a network. The command Router(config-router)# no version 2 is entered on the routers. What effect does entering this command have on routing updates?
Subnet masks will be added to the routing updates. Routing updates will be sent out using multicast address 224.0.0.9. Version 1 and 2 up...
Which option represents a point-to-point logical topology diagram?
Correct Answer Option 4
Which Command Enable debug PPP CHAP Authentication
debug chap authentication debug ppp chap authentication debug authentication debug ppp authentication
How to Check Centos Version | Determine Centos Version
How to Get Centos Version You Can Use cat /etc/centos-release Command.Also Using cat /etc/redhat-release and cat /etc/*release* Comman...
What are the default terminal emulation software settings when configuring a Cisco device through a console port?
Bits per second: 19200 Data bits: 7 Parity: None Stop bits: 0 Flow control: None Bits per second: 9600 Data bits: 8 Parity: None...
Which option correctly identifies the interface or interfaces used to connect the router to a CSU/DSU for WAN connectivity?
Which Command Encrypt all password in plain text in a Cisco router or witch
service password-encryption service-password encryption enable secret enable password
Which routing protocol use diffusing update algorithm (DUAL)
IGRP OSPF EIGRP IS-IS
A network technician is configuring a Cisco 2811 router. The technician types conf at the privileged level command prompt and presses the TAB key. What action will the router take?
It will revert to the user mode. It will perform an auto-complete function. It will go into the global configuration mode. It will give a...
Refer to the exhibit. Host A is configured with the correct IP address for the default gateway of the router R1 FastEthernet0/1 interface. How will a packet that is sent from host A to host B be handled by the devices on the network?
R1 will drop the packet because R1 does not have a specific route in its routing table to the 10.1.1.0/24 network. R1 will forward the p...