decapsulates the Layer 3 packet by stripping off the
Layer 2 frame header
uses the destination MAC Address in the IP Header to look up the next-hop
address in the routing table
leaves the Layer 2 frame header intact when decapsulating the Layer 3 packet
uses the destination IP Address in the IP header to
look up the next-hop address in the routing table
encapsulates the Layer 3 packet into the new Layer 2
frame and forwards it out the exit interface
encapsulates the Layer 3 packet into a special Layer 1 frame and forwards it to
the exit interface
Popular Posts
-
How to Get Centos Version You Can Use cat /etc/centos-release Command.Also Using cat /etc/redhat-release and cat /etc/*release* Comman... -
the same process ID the same area ID network addresses and wildcard masks the same router ID the same loop back address
-
IGRP OSPF EIGRP IS-IS
-
It will revert to the user mode. It will perform an auto-complete function. It will go into the global configuration mode. It will give a...
-
Layer 1 Layer 3 Layer 4 Layer 5
-
path determination and packet switching data presentation reliability, flow control, and error detection network media control the div...
-
Subnet masks will be added to the routing updates. Routing updates will be sent out using multicast address 224.0.0.9. Version 1 and 2 up...
-
R1 will drop the packet because R1 does not have a specific route in its routing table to the 10.1.1.0/24 network. R1 will forward the p... -
Enable split horizon in the network. Configure RIPv2 on routers. Add network 192.168.1.0 to the RIP configuration on the JAX router. ... -
Bits per second: 19200 Data bits: 7 Parity: None Stop bits: 0 Flow control: None Bits per second: 9600 Data bits: 8 Parity: None...