The rate would be negotiated by both routers.
A rate would not be selected due to the DCE/DTE connection mismatch.
The rate configured on the DTE determines the clock rate.
The rate configured on the DCE determines the clock rate.
Refer to the exhibit. Given the output in the exhibit, how would a clock rate be determined for this link?
The rate would be negotiated by both routers.
A rate would not be selected due to the DCE/DTE connection mismatch.
The rate configured on the DTE determines the clock rate.
The rate configured on the DCE determines the clock rate.
Popular Posts
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
The IOS image is corrupt. Cisco IOS is missing from flash memory. The configuration file is missing from NVRAM. The POST process has dete...
-
router hub switch firewall access point bridge
-
straight-through rollover cross-over serial
-
Router1 will perform recursive lookup and packet will exit S0/0. Router1 will perform recursive lookup and packet will exit S0/1. Ther... -
The destination networks do not exist. The IP addresses on the router interfaces must be configured as network addresses and not host a... -
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol... -
encapsulation flow control connectionless services session establishment numbering and sequencing best effort delivery
-
HA DRS FT Storage DRS