The cable is suitable for connecting dissimilar types of devices. The cable is unusable and must be rewired.
The cable is terminated in a way that the transmit pin is wired to the receive pin.
The cable simulates a point-to-point WAN link
Refer to the exhibit. While configuring a network, a technician wired each end of a Category 5e cable as shown. Which two statements are true about this setup? (Choose two.)
The cable is suitable for connecting dissimilar types of devices. The cable is unusable and must be rewired.
The cable is terminated in a way that the transmit pin is wired to the receive pin.
The cable simulates a point-to-point WAN link
Popular Posts
-
IGRP RIPv1 RIPv2 EIGRP
-
port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware Power over Ethernet (PoE)
-
110 90 120 100
-
Refer to the exhibit. The network administrator issues the command no ip classless on Router1. What forwarding action will take place on a... -
It is used to manage the router. It is used for packet receiving and forwarding. It is used to interconnect various types of LANs. It is ...
-
debug chap authentication debug ppp chap authentication debug authentication debug ppp authentication
-
Layer 1 Layer 3 Layer 4 Layer 5
-
low port density high forwarding rate high latency level support link aggregation predefined number of ports
-
The router will install the first route it learned into the routing table. The router will install both routes in the routing table and lo...
-
The OSPF protocol has a higher cost than EIGRP. The EIGRP protocol has a lower metric than OSPF. The EIGRP protocol was configured first o...