Interface S0/0/0 on router R1 is configured with an incorrect IP address.
Interface S0/0/0 on router R2 is administratively down.Interface S0/0/0 on router R2 does not have the clock rate settings configured.
Refer to the exhibit. A network administrator tries to test the connectivity between routers R1 and R2, but the attempt to ping is unsuccessful. Based on the show ip interface brief command outputs, what could be the possible cause of the problem?
Interface S0/0/0 on router R1 is configured with an incorrect IP address.
Interface S0/0/0 on router R2 is administratively down.Interface S0/0/0 on router R2 does not have the clock rate settings configured.
Popular Posts
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
The IOS image is corrupt. Cisco IOS is missing from flash memory. The configuration file is missing from NVRAM. The POST process has dete...
-
router hub switch firewall access point bridge
-
straight-through rollover cross-over serial
-
Router1 will perform recursive lookup and packet will exit S0/0. Router1 will perform recursive lookup and packet will exit S0/1. Ther... -
The destination networks do not exist. The IP addresses on the router interfaces must be configured as network addresses and not host a... -
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol... -
encapsulation flow control connectionless services session establishment numbering and sequencing best effort delivery
-
HA DRS FT Storage DRS