cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. The network administrator has configured the router with the interface IP addresses shown for the directly connected networks. Pings from the router to hosts on the connected networks or pings between router interfaces are not working. What is the most likely problem?
The destination networks do not exist.
The IP addresses on the router interfaces must be configured as network addresses and not host addresses.
The interfaces must be enabled with the no shutdown command.
Each interface must be configured with the clock rate command.
Popular Posts
-
Refer to the exhibit. The network administrator issues the command no ip classless on Router1. What forwarding action will take place on a...
-
Layer 1 Layer 3 Layer 4 Layer 5
-
It is used to manage the router. It is used for packet receiving and forwarding. It is used to interconnect various types of LANs. It is ...
-
debug chap authentication debug ppp chap authentication debug authentication debug ppp authentication
-
port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware Power over Ethernet (PoE)
-
110 90 120 100
-
90 110 120 105 115
-
low port density high forwarding rate high latency level support link aggregation predefined number of ports
-
The OSPF protocol has a higher cost than EIGRP. The EIGRP protocol has a lower metric than OSPF. The EIGRP protocol was configured first o...
-
The router modifies the TTL field, decrementing it by one. The router changes the source IP to the IP of the exit interface. The router ma...
