Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which two characteristics are associated with enterprise level switches? (Choose two.)
low port density
high forwarding rate
high latency level
support link aggregation
predefined number of ports
ccna exploration 3 chapter 1 Exam Question And Answers
Which two characteristics are associated with enterprise level switches? (Choose two.)
Newer Post
Older Post
Home
Popular Posts
Refer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The network that contains the serial link has already been addressed out of a separate range. Each network will be allocated the same number of host addresses. Which network mask will be appropriate to address the remaining networks?
Refer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The n...
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
source end transfer intermediary
show interface status Cisco command reference basic Cisco configuration
Command : show interfaces status Use In : Privileged EXEC Mode Cisco IOS Command show interfaces status use in switches to view cur...
Refer to the exhibit. Which route will be installed in the routing table on R1 to forward traffic from PC1 to the web server?
Refer to the exhibit. Which route will be installed in the routing table on R1 to forward traffic from PC1 to the web server? the stati...
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
Refer to the exhibit. What OSPF network statements are required for the router B to advertise the three networks that are attached?
Refer to the exhibit. What OSPF network statements are required for the router B to advertise the three networks that are attached? rou...
Refer to the exhibit. When host A sends a frame addressed for host D, which hosts will receive the frame?
Refer to the exhibit. When host A sends a frame addressed for host D, which hosts will receive the frame?
Refer to the exhibit. A network administrator tries to test the connectivity between routers R1 and R2, but the attempt to ping is unsuccessful. Based on the show ip interface brief command outputs, what could be the possible cause of the problem?
Interface S0/0/0 on router R1 is shut down. Interface S0/0/0 on router R1 is configured with an incorrect IP address. Interface S0/0/0...
If a router cannot find a valid configuration file during the startup sequence, what will occur?
The startup sequence will reset. The router will prompt the user for a response to enter setup mode. The startup sequence will halt unti...
Refer to the exhibit. All routers are properly configured with default configurations and are running the OSPF routing protocol. The network is fully converged. A host on the 192.168.3.0/24 network is communicating with a host on the 192.168.2.0/24 network.
Refer to the exhibit. All routers are properly configured with default configurations and are running the OSPF routing protocol. The netwo...