Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
When a router boots, what is the default order to locate the Cisco IOS if there is no boot system command?
ROM, TFTP server, flash
flash, TFTP server, ROM
flash, NVRAM, TFTP server
NVRAM, TFTP server, flash
ccna 2 final Exam Question And Answers
O
When a router boots, what is the default order to locate the Cisco IOS if there is no boot system command?
Newer Post
Older Post
Home
Popular Posts
Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still valid in the routing table of Router1. How much longer will it take for Router1 to mark the route invalid by setting the metric to 16?
Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still valid in the rout...
Which email components are used to forward mail between servers? (Choose two.)
MDA IMAP MTA POP SMTP MUA
The network administrator needs to connect two routers directly via their FastEthernet ports. What cable should the network administrator use?
straight-through rollover cross-over serial
What statement describes the purpose of a default route?
A host uses a default route to transfer data to another host on the same network segment. A host uses a default route to forward data to the...
Refer to the exhibit. What is the significance of the /8 in the route to the 10.0.0.0 network?
It indicates that there are 8 hops between this router and the 10.0.0.0 network. It represents the time, in milliseconds, it takes for ...
You have been asked to design a system with following VMware functionality enabled
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
Because of a topology change, the next hop IP address in the current static route must be reconfigured. How can a static route entry be altered to accommodate a topology change?
Keep the existing static route and configure a new static route with the correct next hop IP address. Negate the existing static route and ...
Which three IPv4 addresses represent subnet broadcast addresses? (Choose three.)
192.168.4.63 /26 192.168.4.129 /26 192.168.4.191 /26 192.168.4.51 /27 192.168.4.95 /27
A router learns two paths with equal metrics to a destination network via the RIP routing protocol. How will the router handle packets to the destination network?
The router will install the first route it learned into the routing table. The router will install both routes in the routing table and lo...
Which layer of the OSI model supplies services that allow user to interface with the network?
physical session network presentation application transport