Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which two features are supported at all three levels of the Cisco three-layer hierarchical model? (Choose two.)
Power over Ethernet
load balancing across redundant trunk links
redundant components
Quality of Service
link aggregation
ccna exploration 3 chapter 1 Exam Question And Answers
Which two features are supported at all three levels of the Cisco three-layer hierarchical model? (Choose two.)
Newer Post
Older Post
Home
Popular Posts
Best Books for Cisco Ccna Exam preparation
Cisco CCNA Routing and Switching 200-120 Official Cert Guide Library By Wendell Odom Pages: 1600 Publisher Cisco Press Cisco CCNA R...
Which router component will have contents erased when the command erase startup-config is issued?
flash RAM ROM NVRAM
What are two structured engineering principles necessary for successful implementation of a network design? (Choose two.)
modularity security availability quality of service resiliency
Which piece of information is available from examining the output of the command show ip interface brief?
Interface speed and duplex Interface MTU Errors Interface MAC address Interface IP address
Which of the following will still function if vCenter crashes?
HA DRS FT Storage DRS
Which two statements are true regarding the function of the RIPv1 routing updates? (Choose two).
updates are broadcast only when there are changes to the topology updates are broadcast at regular intervals broadcast are sent to 0.0.0....
A network administrator is troubleshooting a RIPv2 network that is not converging as expected. Which command can the administrator use on each router to view the RIPv2 updates as they are received?
debug ip rip show ip route debug ip routing show ip protocols show ip interface brief
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on each router:
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac...
Refer to the exhibit. Host A is unable to access the Internet. What is the reason for this?
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur...
When the destination network is not listed in the routing table of a Cisco router, what are two possible actions that the router might take? (Choose two.)
The router sends an ARP request to determine the required next hop address. The router discards the packet. The router forwards t...