cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. Which set of commands will configure static routes that will allow the WinterPark and the Altamonte routers to deliver packets from each LAN and direct all other traffic to the Internet?
WinterPark(config)# ip route 0.0.0.0 0.0.0.0 192.168.146.1 Altamonte(config)# ip route 10.0.234.0 255.255.255.0 192.168.146.2 Altamonte(config)# ip route 0.0.0.0 0.0.0.0 s0/1
WinterPark(config)# ip route 0.0.0.0 0.0.0.0 192.168.146.1 Altamonte(config)# ip route 10.0.234.0 255.255.255.0 192.168.146.2 Altamonte(config)# ip route 198.18.222.0 255.255.255.255 s0/1
WinterPark(config)# ip route 172.191.67.0 255.255.255.0 192.168.146.1 WinterPark(config)# ip route 0.0.0.0 0.0.0.0 192.168.146.1 Altamonte(config)# ip route 10.0.234.0 255.255.255.0 192.168.146.2
WinterPark(config)# ip route 172.191.67.0 255.255.255.0 192.168.146.1 Altamonte(config)# ip route 10.0.234.0 255.255.255.0 192.168.146.2 Altamonte(config)# ip route 0.0.0.0 0.0.0.0 s0/0
Popular Posts
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
The host is unable to communicate on the local network. The host can communicate with other hosts on the local network, but is unable t...
-
The addresses are 48 bits long. Network layer addressing is used by Ethernet switches to make forwarding decisions. It uses a hierarchi...
-
source end transfer intermediary
-
Refer to the exhibit. A network technician has been allocated the 192.168.1.0/24 private IP address range for use in the network that sh...
-
the minimum interval, measured in bit-times, that any station must wait before sending another frame the maximum interval, measured in bit-t...
-
the destination device on the local media the destination host address the bits that will be transferred over the media the source appl...
-
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
-
Refer to the exhibit. Host1 is in the process of setting up a TCP session with Host2. Host1 has sent a SYN message to begin session esta...
-
Refer to the exhibit. The network in the exhibit is fully operational. What two statements correctly describe the routing for the top...
