All changes will be lost and the router will restart immediately.
Changes will be saved automatically and the router will restart.
The user will be prompted to save changes before the router restarts.The router will detect changes to the running configuration and will reload using the configuration stored in RAM.
Popular Posts
-
port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware Power over Ethernet (PoE)
-
MDA IMAP MTA POP SMTP MUA
-
OSPF supports VLSM. RIPv1 supports VLSM. RIPv2 does not have a hop count limit. EIGRP supports discontiguous network designs. RIPv2 does...
-
Refer to the exhibit. Which two statements are true based on the exhibited output? (Choose two.) Automatic summarization is disabled... -
192.168.4.63 /26 192.168.4.129 /26 192.168.4.191 /26 192.168.4.51 /27 192.168.4.95 /27
-
The startup sequence will reset. The router will prompt the user for a response to enter setup mode. The startup sequence will halt unti...
-
The router will install the first route it learned into the routing table. The router will install both routes in the routing table and lo...
-
The destination networks do not exist. The IP addresses on the router interfaces must be configured as network addresses and not host a... -
It will revert to the user mode. It will perform an auto-complete function. It will go into the global configuration mode. It will give a...
-
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...