It will send the frame back to host A.It will send the frame to all hosts except host A.
It will forward the frame to the default gateway.
Refer to the exhibit. Host A sends a frame with the destination MAC address as FFFF.FFFF.FFFF. What action will the switch take for this frame?
It will send the frame back to host A.It will send the frame to all hosts except host A.
It will forward the frame to the default gateway.
Popular Posts
-
source and destination MAC source and destination application protocol source and destination port number source and destination IP a...
-
Refer to the exhibit. RouterB is configured properly. The Ethernet interface Fa0/0 of RouterA is configured with the use of the commands... -
The rate would be negotiated by both routers. A rate would not be selected due to the DCE/DTE connection mismatch. The rate configured... -
HDLC frame-relay ppp Dot1q
-
It will revert to the user mode. It will perform an auto-complete function. It will go into the global configuration mode. It will give a...
-
Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still valid in the rout... -
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
Client Transparent Host Workstation
-
RIP uses bandwidth as a metric. OSPF uses delay as a metric. EIGRP uses bandwidth as a metric. OSPF uses cost based on bandwidth as a m...
-
places it immediately in the routing table adjusts the metric for the new route to show the added distance for the route advertises this...