Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
source
end
transfer
intermediary
Newer Post
Older Post
Home
Popular Posts
You have been asked to design a system with following VMware functionality enabled
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
What are three common methods for setting a UTP Ethernet port to MDI or MDIX operation? (Choose three.)
direct configuration of the device cable color code association cable selection and configuration use of cable testers to determine pino...
Best Books for Cisco Ccna Exam preparation
Cisco CCNA Routing and Switching 200-120 Official Cert Guide Library By Wendell Odom Pages: 1600 Publisher Cisco Press Cisco CCNA R...
The output of the Router# show interfaces serial 0/1 command displays the following: Serial0/1 is up, line protocol is down. What is the most likely cause for the line protocol being down?
Serial0/1 is shutdown. There is no cable connecting the routers. The remote router is using serial 0/0. No clock rate has been set.
Refer to the exhibit. What two pieces of information can be determined from the output that is shown? (Choose two.)
Refer to the exhibit. What two pieces of information can be determined from the output that is shown? (Choose two.) The local host is...
The following line of code is displayed in a routing table: R 209.165.201.0/24 [120/2] via 192.168.252.2, 00:00:16, S0/0/0 What can be concluded from this output?
A packet destined for host 192.168.252.2 will be forwarded out the interface connected to network 209.165.201.0/24. The value, 120, is use...
Why is fast convergence desirable in networks that use dynamic routing protocols?
Hosts are unable to access their gateway until the network is converged. Routers will not allow packets to be forwarded until the network i...
A network administrator is selecting a switch that will operate at the network core. Which three features should the switch support for optimum network performance and reliability? (Choose three.)
port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware Power over Ethernet (PoE)
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol. R1 and R2 can ping the directly connected serial interface of their neighbor, but they cannot form an EIGRP neighbor adjacency.
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol...
Which fiber connector supports full duplex Ethernet?
Third one is the correct Answer