Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
What is the maximum network diameter permitted by the default metric of RIPv2?
15 hops
16 hops
100 hops
120 hops
255 hops
ccna exploration 2 chapter 7 Exam Question And Answers
What is the maximum network diameter permitted by the default metric of RIPv2?
Newer Post
Older Post
Home
Popular Posts
A network administrator is selecting a switch that will operate at the network core. Which three features should the switch support for optimum network performance and reliability? (Choose three.)
port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware Power over Ethernet (PoE)
Which email components are used to forward mail between servers? (Choose two.)
MDA IMAP MTA POP SMTP MUA
Which two statements about routing protocols are accurate? (Choose two.)
OSPF supports VLSM. RIPv1 supports VLSM. RIPv2 does not have a hop count limit. EIGRP supports discontiguous network designs. RIPv2 does...
Refer to the exhibit. Which two statements are true based on the exhibited output? (Choose two.)
Refer to the exhibit. Which two statements are true based on the exhibited output? (Choose two.) Automatic summarization is disabled...
Which three IPv4 addresses represent subnet broadcast addresses? (Choose three.)
192.168.4.63 /26 192.168.4.129 /26 192.168.4.191 /26 192.168.4.51 /27 192.168.4.95 /27
If a router cannot find a valid configuration file during the startup sequence, what will occur?
The startup sequence will reset. The router will prompt the user for a response to enter setup mode. The startup sequence will halt unti...
A router learns two paths with equal metrics to a destination network via the RIP routing protocol. How will the router handle packets to the destination network?
The router will install the first route it learned into the routing table. The router will install both routes in the routing table and lo...
Refer to the exhibit. The network administrator has configured the router with the interface IP addresses shown for the directly connected networks. Pings from the router to hosts on the connected networks or pings between router interfaces are not working. What is the most likely problem?
The destination networks do not exist. The IP addresses on the router interfaces must be configured as network addresses and not host a...
A network technician is configuring a Cisco 2811 router. The technician types conf at the privileged level command prompt and presses the TAB key. What action will the router take?
It will revert to the user mode. It will perform an auto-complete function. It will go into the global configuration mode. It will give a...
You have been asked to design a system with following VMware functionality enabled
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...