cisco certification 200-125 ccna exam preparation with practice questions and Answers
A router has learned two equal cost paths to a remote network via the EIGRP and RIP protocols. Both protocols are using their default configurations. Which path to the remote network will be installed in the routing table?
the path learned via EIGRP
the path learned via RIP
the path with the highest metric value
both paths with load balancing
Popular Posts
-
destination network address source network address source MAC address well known port destination address
-
destination logical address source physical address default gateway address source port
-
The packet is sent to discover neighbors within the EIGRP network. The packet is sent to search for network devices within an EIGRP network...
-
Router> Router# Router(config)# Router(config-if)#
-
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
-
BNC RJ-11 RJ-45 Type F
-
load delay reliability hop count bandwidth
-
It is saved in the topology table for use if the primary route fails. It may be backed up by a feasible successor route. It is used by EIG...
-
forwarding rate traffic flow analysis expected future growth number of required core connections number of hubs that are needed in the acces...
-
What is a component of a routing table entry? the MAC address of the interface of the router the destination Layer 4 port number the ...