cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. The command ip route 0.0.0.0 0.0.0.0 S0/0/0 is run on router R2. What are the two results of this command? (Choose two.)
A static route will be updated in the routing table.
The traffic from the Internet will be directed to R2.
The traffic from the source network 172.16.0.0/22 will be blocked.
The route will be specified as the default route for all networks not defined in the routing table.
All the broadcasts will be forwarded via the S0/0/0 interface of R2.
Popular Posts
-
destination network address source network address source MAC address well known port destination address
-
destination logical address source physical address default gateway address source port
-
The packet is sent to discover neighbors within the EIGRP network. The packet is sent to search for network devices within an EIGRP network...
-
Router> Router# Router(config)# Router(config-if)#
-
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
-
BNC RJ-11 RJ-45 Type F
-
load delay reliability hop count bandwidth
-
It is saved in the topology table for use if the primary route fails. It may be backed up by a feasible successor route. It is used by EIG...
-
forwarding rate traffic flow analysis expected future growth number of required core connections number of hubs that are needed in the acces...
-
What is a component of a routing table entry? the MAC address of the interface of the router the destination Layer 4 port number the ...