Router1(config)# ip classless
Router1(config-router)# network 192.168.16.0
Router1(config-router)# no passive-interface serial 0/1/1
Router2(config-router)# version 2
Router2(config-router)# neighbor 10.0.0.2
Refer to the exhibit. Which command will allow Router2 to learn about the 192.168.16.0/28 network?
Router1(config)# ip classless
Router1(config-router)# network 192.168.16.0
Router1(config-router)# no passive-interface serial 0/1/1
Router2(config-router)# version 2
Router2(config-router)# neighbor 10.0.0.2
Popular Posts
-
How to Get Centos Version You Can Use cat /etc/centos-release Command.Also Using cat /etc/redhat-release and cat /etc/*release* Comman... -
the same process ID the same area ID network addresses and wildcard masks the same router ID the same loop back address
-
IGRP OSPF EIGRP IS-IS
-
It will revert to the user mode. It will perform an auto-complete function. It will go into the global configuration mode. It will give a...
-
Layer 1 Layer 3 Layer 4 Layer 5
-
path determination and packet switching data presentation reliability, flow control, and error detection network media control the div...
-
Subnet masks will be added to the routing updates. Routing updates will be sent out using multicast address 224.0.0.9. Version 1 and 2 up...
-
R1 will drop the packet because R1 does not have a specific route in its routing table to the 10.1.1.0/24 network. R1 will forward the p... -
Enable split horizon in the network. Configure RIPv2 on routers. Add network 192.168.1.0 to the RIP configuration on the JAX router. ...
