cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. All routers are running RIP version 2. JAX is configured to just advertise the 10.0.0.0/24 network. CHI is configured to advertise the 172.16.0.0/16 network. A network administrator enters the commands shown in the exhibit. What changes will occur in this network?
The JAX router will ignore updates for the 172.16.0.0/16 network due to split horizon issues.
The CHI router will install a route to the 192.168.0.0/16 network in its routing table.
The routing table for CHI will have the 192.168.0.0/16 route but it will have an S next to the route.
The ORL router will apply a 255.255.0.0 subnet mask to all networks in the routing updates it forwards.
Popular Posts
-
greater distances per cable run lower installation cost limited susceptibility to EMI/RFI durable connections greater bandwidth potential e...
-
source end transfer intermediary
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
Use the ipconfig command at the host. Use the ipconfig/all command at the destination. Use the tracert command at the host.
-
Data will be forwarded to the wrong node. Data transmitted through that cable may experience signal loss. An improper signaling method w...
-
A Class C address has been assigned for use in the network shown in the graphic. Using VLSM, which bit mask should be used to provide ...
-
html p tag (paragraph tag) use to add paragraphs in html <p>this is a html paragraph</p> <p>html code for new parag...
-
1. pings from R1 to the S0/0/0 interface on R2….successful 2. pings from R1 to the Fa0/0 interface on R2….successful 3. pings from host...
-
Refer to the exhibit. All routers in the exhibit are running RIP v1. The network administrator issues the show ip route command on ro...
-
The router will be reset to the default factory information. The router will not forward routing information that is learned from other rou...
