The IP address of host A is incorrect.
The default gateway of host A is incorrect.
The Fa0/1 interfaces of the two routers are configured for different subnets.
The subnet mask for the Fa0/0 interface of R1 is incorrect.
Refer to the exhibit. Host A is unable to access the Internet. What is the reason for this?
The IP address of host A is incorrect.
The default gateway of host A is incorrect.
The Fa0/1 interfaces of the two routers are configured for different subnets.
The subnet mask for the Fa0/0 interface of R1 is incorrect.
Popular Posts
-
Which of the following statements are correct regarding EIGRP EIGRP uses bandwidth and delay as its composite metric by default EIGRP supp...
-
destination logical address source physical address default gateway address source port
-
POST code the routing table the running-configuration the start-up configuration the bootstrap instructions a copy of the operating sys...
-
cable color code association cable selection and configuration use of cable testers to determine pinouts the automatic detection and negotia...
-
core only distribution and core access and distribution access, distribution, and core
-
the network requires a special hierarchical design fast convergence of the network is crucial the network is using a hub and spoke topolo...
-
clears an unreachable route from the routing table after the invalid timer expires prevents regular update messages from inappropriately ...
-
application access distribution network core
-
Which of the following would be the correct command sequence to enable RIP on Router B for all connected networks? RouterB# router ... -
It connects multiple IP networks. It controls the flow of data via the use of Layer 2 addresses. It determines the best path to send pac...