RIP is a link-state routing protocol.
RIP uses only one metric—hop count— for path selection.
Advertised routes with hop counts greater than 10 are unreachable.
Messages are broadcast every 10 seconds.
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Popular Posts
-
Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still valid in the rout...
-
MDA IMAP MTA POP SMTP MUA
-
straight-through rollover cross-over serial
-
A host uses a default route to transfer data to another host on the same network segment. A host uses a default route to forward data to the...
-
It indicates that there are 8 hops between this router and the 10.0.0.0 network. It represents the time, in milliseconds, it takes for ...
-
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
-
Keep the existing static route and configure a new static route with the correct next hop IP address. Negate the existing static route and ...
-
192.168.4.63 /26 192.168.4.129 /26 192.168.4.191 /26 192.168.4.51 /27 192.168.4.95 /27
-
The router will install the first route it learned into the routing table. The router will install both routes in the routing table and lo...
-
physical session network presentation application transport