Refer to the exhibit. A ping between host A and host B is
successful, but pings from host A to operational hosts on the Internet fail.
What is the reason for this problem?
The FastEthernet interface of R1 is disabled.
One of the default routes is configured incorrectly.
A routing protocol is not configured on both routers.
The default gateway has not been configured on host A.
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Popular Posts
-
Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still valid in the rout...
-
MDA IMAP MTA POP SMTP MUA
-
straight-through rollover cross-over serial
-
A host uses a default route to transfer data to another host on the same network segment. A host uses a default route to forward data to the...
-
It indicates that there are 8 hops between this router and the 10.0.0.0 network. It represents the time, in milliseconds, it takes for ...
-
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
-
Keep the existing static route and configure a new static route with the correct next hop IP address. Negate the existing static route and ...
-
192.168.4.63 /26 192.168.4.129 /26 192.168.4.191 /26 192.168.4.51 /27 192.168.4.95 /27
-
The router will install the first route it learned into the routing table. The router will install both routes in the routing table and lo...
-
physical session network presentation application transport
