cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. The network administrator has run the following command on R1.
Refer to the exhibit. The network administrator has run the following command on R1.
R1(config)# ip route 192.168.2.0 255.255.255.0 172.16.1.2
What is the result of running this command?
Traffic for network 192.168.2.0 is forwarded to 172.16.1.2.
This route is automatically propagated throughout the entire network.
Traffic for all networks is forwarded to 172.16.1.2.
The command invokes a dynamic routing protocol for 192.168.2.0.
Popular Posts
-
router hub switch wireless access point
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
source end transfer intermediary
-
1. pings from R1 to the S0/0/0 interface on R2….successful 2. pings from R1 to the Fa0/0 interface on R2….successful 3. pings from host...
-
Router1 will perform recursive lookup and packet will exit S0/0. Router1 will perform recursive lookup and packet will exit S0/1. Ther...
-
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac...
-
loss of signal strength as distance increases time for a signal to reach its destination leakage of signals from one cable pair to anothe...
-
192.168.0.0 – 192.168.32.0/24 192.168.0.0 – 192.168.47.0/24 192.168.32.0 – 192.168.47.0/24 192.168.32.0 – 192.168.48.0/24 192.168.32.0 ...
-
EIGRP can be used with Cisco and non-Cisco routers. EIGRP sends triggered updates whenever there is a change in topology that influences t...
-
Refer to the exhibit. Which option correctly identifies the network address, range of host addresses, and the broadcast address for the n...
