cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. If the attached device is configured correctly, what action can be taken to change the state of FastEthernet0/0 to Up Up?
Refer to the exhibit. If the attached device is configured correctly, what action can be taken to change the state of FastEthernet0/0 to Up Up?
Attach a crossover cable to the interface.
Change the encapsulation on the interface to HDLC.
Issue the no shutdown command for the interface.
Set the clock rate for the interface to 56000.
Popular Posts
-
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
-
HA DRS FT Storage DRS
-
172.16.0.0 172.16.192.0 172.16.192.128 172.16.192.160 172.16.192.168 172.16.192.176
-
A host uses a default route to transfer data to another host on the same network segment. A host uses a default route to forward data to the...
-
R1(config-if)# bandwidth R1(config-if)# ip ospf cost R1(config-if)# ip ospf priority R1(config-if)# ip ospf hello-interval R1(config-ro...
-
Refer to the exhibit. Host_A is attempting to contact Server_B. Which statements correctly describe the addressing Host_A will generate ...
-
clears an unreachable route from the routing table after the invalid timer expires prevents regular update messages from inappropriately ...
-
A LAN is usually in a single geographical area. The network is administered by a single organization. The connection between segments ...
-
Refer to the exhibit. RIPv1 is running on all three routers. All interfaces have been correctly configured with addresses in the addre...
-
How To Check SELinux Status In Linux Command : sestatus Use sestatus Command to Check SELinux Status In You're CentOS Linux Machin...