cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. A network administrator is investigating why data packets with destination addresses of 172.16.10.10 and 192.168.10.100 are being dropped instead of being forwarded via the static route as expected
Refer to the exhibit. A network administrator is investigating why data packets with destination addresses of 172.16.10.10 and 192.168.10.100 are being dropped instead of being forwarded via the static route as expected. After confirming that the ip classless command has been applied on all routers in the network, what other action should the administrator take to ensure that data packets to these addresses are forwarded via the static route?
Check that all routers are configured with the same autonomous system number.
Issue the no auto-summary command within the EIGRP configuration of all routers.
Issue the no passive-interface command within the EIGRP configuration of all routers.
Configure the static route to point to the next hop address instead of the outbound interface.
Popular Posts
-
Router1# copy running-config flash Router1(config)# copy running-config flash Router1# copy running-config startup-config Router1(config...
-
192.1.1.0/26 and 192.1.1.64/27 192.1.1.128/25 192.1.1.0/23 and 192.1.1.64/23 192.1.1.0/24 192.1.1.0/25 192.1.1.0/24 and 192.1.1.64/2...
-
They will share all routes saved in NVRAM prior to the power loss with their directly connected neighbors. They will multicast hello packe...
-
This is a useable host address. This is a broadcast address. This is a network address. This is not a valid address.
-
to indicate the correct router interface that should be used to forward a segment to identify which switch ports should receive or forwa...
-
Refer to the exhibit. A technician is working on a network problem that requires verification of the router LAN interface. What address ...
-
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol...
-
gateways purpose physical addressing software version geographic location ownership
-
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac...
