cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. What path will packets from the 192.168.1.0/24 network travel to reach the 10.0.0.0/8 network if RIP is the active routing protocol?
Refer to the exhibit. What path will packets from the 192.168.1.0/24 network travel to reach the 10.0.0.0/8 network if RIP is the active routing protocol?
The path will be router A -> router B -> router C -> router E.
The path will be router A -> router D -> router E
Router A will load balance between the router A -> router D -> router E and router A -> router B -> router C -> router E path
Packets will alternate paths depending on the order they arrive at router A.
Popular Posts
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
router hub switch wireless access point
-
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac...
-
loss of signal strength as distance increases time for a signal to reach its destination leakage of signals from one cable pair to anothe...
-
192.168.0.0 – 192.168.32.0/24 192.168.0.0 – 192.168.47.0/24 192.168.32.0 – 192.168.47.0/24 192.168.32.0 – 192.168.48.0/24 192.168.32.0 ...
-
EIGRP can be used with Cisco and non-Cisco routers. EIGRP sends triggered updates whenever there is a change in topology that influences t...
-
Refer to the exhibit. Which option correctly identifies the network address, range of host addresses, and the broadcast address for the n...
-
Refer to the exhibit. All routers in the exhibit are running RIP v1. The network administrator issues the show ip route command on ro...
-
A preferred route to the destination has not been set. There are two equal cost paths to network 1 .0.0.0. Both interfaces are being used...
-
Refer to the exhibit. Beginning with HR servers and workstations, a network engineer is designing a new security structure for the networ...
