Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which of the following are displayed by the Router# show cdp neighbors command? (Choose three.)
load
platform
reliability
holdtime
local interface
ccna exploration 2 chapter 2 Exam Question And Answers
Which of the following are displayed by the Router# show cdp neighbors command? (Choose three.)
Newer Post
Older Post
Home
Popular Posts
Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and interfaces that can be protected with passwords. (Choose three.)
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
A router has one static route to each destination network. Which two scenarios would require an administrator to alter the static routes that are configured on that router? (Choose two.)
The destination network no longer exists. The destination network is moved to a different interface on the same router. The path between ...
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
Refer to the exhibit. A network administrator tries to test the connectivity between routers R1 and R2, but the attempt to ping is unsuccessful. Based on the show ip interface brief command outputs, what could be the possible cause of the problem?
Interface S0/0/0 on router R1 is shut down. Interface S0/0/0 on router R1 is configured with an incorrect IP address. Interface S0/0/0...
What is dynamically selected by the source host when forwarding data?
destination logical address source physical address default gateway address source port
Refer to the exhibit. Which type of network design is shown?
client/server wide area dedicated server peer-to-peer
What is the effect of the command copy running-config tftp?
copies the configuration from a remote machine into RAM copies the configuration from a remote machine into NVRAM copies the configuration...
Refer to the exhibit. Both routers are using the RIPv2 routing protocol and static routes are undefined. R1 can ping 192.168.2.1 and 10.1.1.2, but is unable to ping 192.168.4.1.
Refer to the exhibit. Both routers are using the RIPv2 routing protocol and static routes are undefined. R1 can ping 192.168.2.1 and 10.1...
Refer to the exhibit. Interface Fa0/0 on router A is generating excessive broadcast traffic. Which LAN segments will affected by the excessive broadcasts?
Only the 192.168.1.200/30 network will be affected. Only the link between 192.168.1.201 and port Fa0/5 on SW1 will be affected. Both t...
Refer to the exhibit. The network administrator has assigned the internetwork of LBMISS an address range of 192.168.10.0. This address range has been subnetted using a /29 mask. In order to accommodate a new building, the technician has decided to use the fifth subnet for configuring the new network (subnet zero is the first subnet). By company policies, the router interface is always assigned the first usable host address and the workgroup server is given the last usable host address. Which configuration should be entered into the workgroup server’s properties to allow connectivity to the network?
Refer to the exhibit. The network administrator has assigned the internetwork of LBMISS an address range of 192.168.10.0. This address ...