A preferred route to the destination has not been set.
There are two equal cost paths to network 1.0.0.0.
Both interfaces are being used equally to route traffic.
A variance must be set to load-balance across multiple paths.
Popular Posts
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
The IOS image is corrupt. Cisco IOS is missing from flash memory. The configuration file is missing from NVRAM. The POST process has dete...
-
router hub switch firewall access point bridge
-
straight-through rollover cross-over serial
-
Router1 will perform recursive lookup and packet will exit S0/0. Router1 will perform recursive lookup and packet will exit S0/1. Ther... -
The destination networks do not exist. The IP addresses on the router interfaces must be configured as network addresses and not host a... -
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol... -
encapsulation flow control connectionless services session establishment numbering and sequencing best effort delivery
-
HA DRS FT Storage DRS