Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which three IP addresses are private? (Choose three.)
172.168.33.1
10.35.66.70
192.168.99.5
172.18.88.90
192.33.55.89
172.35.16.5
ccna exploration 1 chapter 6 Exam Question And Answers
Which three IP addresses are private? (Choose three.)
Newer Post
Older Post
Home
Popular Posts
RIPv2 is the configured routing protocol on the routers in a network. The command Router(config-router)# no version 2 is entered on the routers. What effect does entering this command have on routing updates?
Subnet masks will be added to the routing updates. Routing updates will be sent out using multicast address 224.0.0.9. Version 1 and 2 up...
Which option represents a point-to-point logical topology diagram?
Correct Answer Option 4
A network technician is configuring a Cisco 2811 router. The technician types conf at the privileged level command prompt and presses the TAB key. What action will the router take?
It will revert to the user mode. It will perform an auto-complete function. It will go into the global configuration mode. It will give a...
Which Command Enable debug PPP CHAP Authentication
debug chap authentication debug ppp chap authentication debug authentication debug ppp authentication
How to Check Centos Version | Determine Centos Version
How to Get Centos Version You Can Use cat /etc/centos-release Command.Also Using cat /etc/redhat-release and cat /etc/*release* Comman...
Which option correctly identifies the interface or interfaces used to connect the router to a CSU/DSU for WAN connectivity?
Which routing protocol use diffusing update algorithm (DUAL)
IGRP OSPF EIGRP IS-IS
In an examination of two OSPF routers that fail to exchange information, it is determined that they have not become OSPF neighbors. Which two configuration values must match for the OSPF routers to become neighbors?
neighbor ID and router ID dead time and hello time OSPF area and neighbor ID OSPF area and interface priority
Which Command Encrypt all password in plain text in a Cisco router or witch
service password-encryption service-password encryption enable secret enable password
What are the default terminal emulation software settings when configuring a Cisco device through a console port?
Bits per second: 19200 Data bits: 7 Parity: None Stop bits: 0 Flow control: None Bits per second: 9600 Data bits: 8 Parity: None...