This is a useable host address.
This is a broadcast address.
This is a network address.
This is not a valid address.
Popular Posts
-
What are two functions of the network command used when configuring routing protocols? (Choose two.)identifies which networks will be included in the routing updates identifies the hosts addresses that can be summarized in the network u...
-
Refer to the exhibit. Routers East and West are configured using RIPv1. Both routers are sending updates about their directly connected ... -
User accounts are centralized. Security is difficult to enforce. Specialized operating system software is required. File perm...
-
An additional subnet is required for a new Ethernet link between Router1 and Router2 as shown in the diagram. Which of the following su... -
Refer to the exhibit. A network technician enters the static route in R1 needed to reach network 10.1.1.0/24. A ping from R1 to Host B f... -
They both use hop count as a metric. They both have the same metric value for infinite distance. They both broadcast their updates to the...
-
uses a broadcast to update all other routers in the network every 60 seconds uses a multicast address to update other routers every 90 sec...
-
Refer to the exhibit. What can be concluded from the routing table output of router B? -
RJ 11 DB 60 Winchester 15 pin DB 9 smart serial RJ 45
-
best metric lowest hop count greatest available bandwidth lowest administrative distance lowest cost