Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. How many unique CRC calculations will take place as traffic routes from the PC to the laptop?
Refer to the exhibit. How many unique CRC calculations will take place as traffic routes from the PC to the laptop?
1
2
4
8
16
Newer Post
Older Post
Home
Popular Posts
Which two conditions would create a setting where the use of a distance-vector routing protocol would be efficient? (Choose two.)
the network requires a special hierarchical design fast convergence of the network is crucial the network is using a hub and spoke topolo...
Refer to the exhibit. The switch and workstation are administratively configured for full-duplex operation. Which statement accurately reflects the operation of this link?
Refer to the exhibit. The switch and workstation are administratively configured for full-duplex operation. Which statement accurately ref...
You have been asked to design a system with following VMware functionality enabled
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
A technician is attempting to explain Cisco StackWise technology to a client that is setting up three stackable switches. Which explanation accurately describes StackWise technology?
StackWise technology allows up to eight ports to be bound together to increase available bandwidth. StackWise technology allows the switch t...
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
The output of the Router# show interfaces serial 0/1 command displays the following: Serial0/1 is up, line protocol is down. What is the most likely cause for the line protocol being down?
Serial0/1 is shutdown. There is no cable connecting the routers. The remote router is using serial 0/0. No clock rate has been set.
Which method of signal transmission uses radio waves to carry signals?
electrical optical wireless acoustic
ccna exploration 1 chapter 2 exam answers
Which statements correctly identify the role of intermediary devices in the network? (Cho...
Refer to the exhibit. A company network engineer is assigned to establish connectivity between the two Ethernet networks so that hosts on the 10.1.1.0/24 subnet can contact hosts on the 10.1.2.0/24 subnet. The engineer has been told to use only static routing for these company routers. Which set of commands will establish connectivity between the two Ethernet networks?
R1(config)# ip route 10.1.2.0 255.255.255.0 192.168.0.1 R2(config)# ip route 10.1.1.0 255.255.255.0 192.168.0.2 R1(config)# ip route ...
A network technician is asked to examine an existing switched network. Following this examination, the technician makes recommendations for adding new switches where needed and replacing existing equipment that hampers performance. The technician is given a budget and asked to proceed. Which two pieces of information would be helpful in determining necessary port density for new switches? (Choose two.)
forwarding rate traffic flow analysis expected future growth number of required core connections number of hubs that are needed in the acces...