Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which process do routers use to determine the subnet network address based upon a given IP address and subnet mask?
binary adding
hexadecimal anding
binary division
binary multiplication
binary ANDing
ccna exploration 1 chapter 6 Exam Question And Answers
Which process do routers use to determine the subnet network address based upon a given IP address and subnet mask?
Newer Post
Older Post
Home
Popular Posts
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
source end transfer intermediary
Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and interfaces that can be protected with passwords. (Choose three.)
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
A company is planning to subnet its network for a maximum of 27 hosts. Which subnet mask would provide the needed hosts and leave the fewest unused addresses in each subnet?
255.255.255.0 255.255.255.192 255.255.255.224 255.255.255.240 255.255.255.248
Refer to the exhibit. Host_A is attempting to contact Server_B. Which statements correctly describe the addressing Host_A will generate in the process? (Choose two.)
Refer to the exhibit. Host_A is attempting to contact Server_B. Which statements correctly describe the addressing Host_A will generate ...
What can be identified by examining the network layer header?
the destination device on the local media the destination host address the bits that will be transferred over the media the source appl...
What is the purpose of the TCP/IP Network Access layer?
path determination and packet switching data presentation reliability, flow control, and error detection network media control the div...
Refer to the exhibit. Host A is unable to access the Internet. What is the reason for this?
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur...
When the destination network is not listed in the routing table of a Cisco router, what are two possible actions that the router might take? (Choose two.)
The router sends an ARP request to determine the required next hop address. The router discards the packet. The router forwards t...
Refer to the exhibit. “Cell A” at IP address 10.0.0.34 has established an IP session with “IP Phone 1″ at IP address 172.16.1.103. Based upon the graphic, which device type best describes the function of wireless device “Cell A?”
Refer to the exhibit. “Cell A” at IP address 10.0.0.34 has established an IP session with “IP Phone 1″ at IP address 172.16.1.103. Base...
Refer to the exhibit. Which set of devices contains only end devices?
A, C, D B, E, G, H C, D, G, H, I, J D, E, F, H, I, J E, F, H, I, J