Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. How many subnets are required to support the network that is shown?
Refer to the exhibit. How many subnets are required to support the network that is shown?
2
3
4
5
Newer Post
Older Post
Home
Popular Posts
Refer to the exhibit. All routers are running RIP version 2. JAX is configured to just advertise the 10.0.0.0/24 network. CHI is configured to advertise the 172.16.0.0/16 network. A network administrator enters the commands shown in the exhibit. What changes will occur in this network?
The JAX router will ignore updates for the 172.16.0.0/16 network due to split horizon issues. The CHI router will install a route to th...
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
A router boots and enters setup mode. What is the reason for this?
The IOS image is corrupt. Cisco IOS is missing from flash memory. The configuration file is missing from NVRAM. The POST process has dete...
What type of network is maintained if a server takes no dedicated role in the network?
mainframe client /server peer-to-peer
View Current Logged in User in Linux | Linux whoami Command
View Linux Current User Command : whoami To View Current Logged in User in Linux you can use whoami command in terminal in you...
Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and interfaces that can be protected with passwords. (Choose three.)
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
Which hierarchical design characteristic would be recommended at both the core and distribution layers to protect the network in the case of a route failure?
PoE redundancy aggregation access lists
Refer to the exhibit. The network administrator has configured the router with the interface IP addresses shown for the directly connected networks. Pings from the router to hosts on the connected networks or pings between router interfaces are not working. What is the most likely problem?
The destination networks do not exist. The IP addresses on the router interfaces must be configured as network addresses and not host a...
The output of the Router# show interfaces serial 0/1 command displays the following: Serial0/1 is up, line protocol is down. What is the most likely cause for the line protocol being down?
Serial0/1 is shutdown. There is no cable connecting the routers. The remote router is using serial 0/0. No clock rate has been set.
Which topology divides the collision domain and provides full media bandwidth to the hosts in the network?