The "http" portion indicates the protocol that is being used.
The "web1.htm" portion is the specific service name.
The retrieved web page will be displayed in URL code.
The "www.cisco.com" is the name of the web page file that is called
Popular Posts
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
router hub switch wireless access point -
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac... -
loss of signal strength as distance increases time for a signal to reach its destination leakage of signals from one cable pair to anothe...
-
192.168.0.0 – 192.168.32.0/24 192.168.0.0 – 192.168.47.0/24 192.168.32.0 – 192.168.47.0/24 192.168.32.0 – 192.168.48.0/24 192.168.32.0 ...
-
EIGRP can be used with Cisco and non-Cisco routers. EIGRP sends triggered updates whenever there is a change in topology that influences t...
-
Refer to the exhibit. Which option correctly identifies the network address, range of host addresses, and the broadcast address for the n... -
Refer to the exhibit. All routers in the exhibit are running RIP v1. The network administrator issues the show ip route command on ro... -
A preferred route to the destination has not been set. There are two equal cost paths to network 1 .0.0.0. Both interfaces are being used...
-
source end transfer intermediary