Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
What are the Valid VTP(Vlan Trunking Protocol) Modes for Cisco catalyst Switch
Server
Host
Transparent
Workstation
Client
User
Server
,
Client
and
Transparent
are the three valid VTP Modes In Cisco Switch, while
Server is The Default VTP Mode
.
Newer Post
Older Post
Home
Popular Posts
How to Check Centos Version | Determine Centos Version
How to Get Centos Version You Can Use cat /etc/centos-release Command.Also Using cat /etc/redhat-release and cat /etc/*release* Comman...
Two routers need to be configured within a single OSPF area. Which two components need to be configured on both routers to achieve this? (Choose two.)
the same process ID the same area ID network addresses and wildcard masks the same router ID the same loop back address
Which routing protocol use diffusing update algorithm (DUAL)
IGRP OSPF EIGRP IS-IS
A network technician is configuring a Cisco 2811 router. The technician types conf at the privileged level command prompt and presses the TAB key. What action will the router take?
It will revert to the user mode. It will perform an auto-complete function. It will go into the global configuration mode. It will give a...
Configuring communication between devices on different VLANs requires the use of which layer of the OSI model?
Layer 1 Layer 3 Layer 4 Layer 5
Which option correctly identifies the interface or interfaces used to connect the router to a CSU/DSU for WAN connectivity?
What is the purpose of the TCP/IP Network Access layer?
path determination and packet switching data presentation reliability, flow control, and error detection network media control the div...
RIPv2 is the configured routing protocol on the routers in a network. The command Router(config-router)# no version 2 is entered on the routers. What effect does entering this command have on routing updates?
Subnet masks will be added to the routing updates. Routing updates will be sent out using multicast address 224.0.0.9. Version 1 and 2 up...
Refer to the exhibit. Host A is configured with the correct IP address for the default gateway of the router R1 FastEthernet0/1 interface. How will a packet that is sent from host A to host B be handled by the devices on the network?
R1 will drop the packet because R1 does not have a specific route in its routing table to the 10.1.1.0/24 network. R1 will forward the p...
Refer to the exhibit. The exhibited network contains a mixture of Cisco and non-Cisco routers. The command debug ip rip was entered on the JAX router. All routers are running the same version of RIP. Router CHI and Router ORL are not able to reach the 192.168.1.16/28 network. What is a possible solution to this problem?
Enable split horizon in the network. Configure RIPv2 on routers. Add network 192.168.1.0 to the RIP configuration on the JAX router. ...