Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
What are Two Characteristics of RIPv2 Routing Protocol
Manual Route Summarization
Use Bandwidth as Cost
Unequal Cost Load Balancing
Manage a Topology Table
Classless Routing Protocol
Newer Post
Older Post
Home
Popular Posts
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
source end transfer intermediary
Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and interfaces that can be protected with passwords. (Choose three.)
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
A company is planning to subnet its network for a maximum of 27 hosts. Which subnet mask would provide the needed hosts and leave the fewest unused addresses in each subnet?
255.255.255.0 255.255.255.192 255.255.255.224 255.255.255.240 255.255.255.248
What is the purpose of the TCP/IP Network Access layer?
path determination and packet switching data presentation reliability, flow control, and error detection network media control the div...
Refer to the exhibit. Host A is unable to access the Internet. What is the reason for this?
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur...
When the destination network is not listed in the routing table of a Cisco router, what are two possible actions that the router might take? (Choose two.)
The router sends an ARP request to determine the required next hop address. The router discards the packet. The router forwards t...
Refer to the exhibit. “Cell A” at IP address 10.0.0.34 has established an IP session with “IP Phone 1″ at IP address 172.16.1.103. Based upon the graphic, which device type best describes the function of wireless device “Cell A?”
Refer to the exhibit. “Cell A” at IP address 10.0.0.34 has established an IP session with “IP Phone 1″ at IP address 172.16.1.103. Base...
Which of the following describe interframe spacing? (Choose two.)
the minimum interval, measured in bit-times, that any station must wait before sending another frame the maximum interval, measured in bit-t...
Refer to the exhibit. R1 is configured properly for a single area OSPF, and R2 has been recently installed in the network. Which set of commands is required to configure a single area OSPF for the networks that are connected to R2?
R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.1.1.0 0.0.0.3 area 0 ...
Which email components are used to forward mail between servers? (Choose two.)
MDA IMAP MTA POP SMTP MUA