Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Link aggregation should be implemented at which layer of the hierarchical network?
core only
distribution and core
access and distribution
access, distribution, and core
ccna exploration 3 chapter 1 Exam Question And Answers
Link aggregation should be implemented at which layer of the hierarchical network?
Newer Post
Older Post
Home
Popular Posts
Refer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The network that contains the serial link has already been addressed out of a separate range. Each network will be allocated the same number of host addresses. Which network mask will be appropriate to address the remaining networks?
Refer to the exhibit. A network administrator has to develop an IP addressing scheme that uses the 192.168.1.0 /24 address space. The n...
Refer to the exhibit. Which term correctly identifies the device type that is included in the area B?
source end transfer intermediary
Refer to the exhibit. When host A sends a frame addressed for host D, which hosts will receive the frame?
Refer to the exhibit. When host A sends a frame addressed for host D, which hosts will receive the frame?
Refer to the exhibit. Which route will be installed in the routing table on R1 to forward traffic from PC1 to the web server?
Refer to the exhibit. Which route will be installed in the routing table on R1 to forward traffic from PC1 to the web server? the stati...
show interface status Cisco command reference basic Cisco configuration
Command : show interfaces status Use In : Privileged EXEC Mode Cisco IOS Command show interfaces status use in switches to view cur...
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
Refer to the exhibit. What OSPF network statements are required for the router B to advertise the three networks that are attached?
Refer to the exhibit. What OSPF network statements are required for the router B to advertise the three networks that are attached? rou...
Refer to the exhibit. All routers are running RIPv1. What changes will occur in the routing table of router B if a loopback interface with an address of 10.16.1.129/27 is configured on router B?
Routes to the 10.16.1.0/27, 10.16.1.64/27, and 10.16.1.128/27 networks are added. A connected route to the 10.16.1.128/27 network is ad...
Refer to the exhibit. A network administrator tries to test the connectivity between routers R1 and R2, but the attempt to ping is unsuccessful. Based on the show ip interface brief command outputs, what could be the possible cause of the problem?
Interface S0/0/0 on router R1 is shut down. Interface S0/0/0 on router R1 is configured with an incorrect IP address. Interface S0/0/0...
If a router cannot find a valid configuration file during the startup sequence, what will occur?
The startup sequence will reset. The router will prompt the user for a response to enter setup mode. The startup sequence will halt unti...