Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. Using the network in the exhibit, what would be the default gateway address for host A in the 192.133.219.0 network?
192.135.250.1
192.31.7.1
192.133.219.0
192.133.219.1
ccna exploration 1 chapter 5 Exam Question And Answers
Refer to the exhibit. Using the network in the exhibit, what would be the default gateway address for host A in the 192.133.219.0 network?
Newer Post
Older Post
Home
Popular Posts
A router has one static route to each destination network. Which two scenarios would require an administrator to alter the static routes that are configured on that router? (Choose two.)
The destination network no longer exists. The destination network is moved to a different interface on the same router. The path between ...
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (Choose two.)
Refer to the exhibit. What two commands will change the next-hop address for the 10.0.0.0/8 network from 172.16.40.2 to 192.168.1.2? (C...
Passwords can be used to restrict access to all or parts of the Cisco IOS. Select the modes and interfaces that can be protected with passwords. (Choose three.)
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
What is dynamically selected by the source host when forwarding data?
destination logical address source physical address default gateway address source port
Refer to the exhibit. Which type of network design is shown?
client/server wide area dedicated server peer-to-peer
What is the effect of the command copy running-config tftp?
copies the configuration from a remote machine into RAM copies the configuration from a remote machine into NVRAM copies the configuration...
Refer to the exhibit. Both routers are using the RIPv2 routing protocol and static routes are undefined. R1 can ping 192.168.2.1 and 10.1.1.2, but is unable to ping 192.168.4.1.
Refer to the exhibit. Both routers are using the RIPv2 routing protocol and static routes are undefined. R1 can ping 192.168.2.1 and 10.1...
Why are port numbers included in the TCP header of a segment?
to indicate the correct router interface that should be used to forward a segment to identify which switch ports should receive or forwa...
Refer to the exhibit. The network administrator has assigned the internetwork of LBMISS an address range of 192.168.10.0. This address range has been subnetted using a /29 mask. In order to accommodate a new building, the technician has decided to use the fifth subnet for configuring the new network (subnet zero is the first subnet). By company policies, the router interface is always assigned the first usable host address and the workgroup server is given the last usable host address. Which configuration should be entered into the workgroup server’s properties to allow connectivity to the network?
Refer to the exhibit. The network administrator has assigned the internetwork of LBMISS an address range of 192.168.10.0. This address ...
What are Two Method use by RIP Routing protocol to avoid Routing Loops
Split horizon rule Maximum Hop Count Spanning tree protocol Elect DR and BDR