cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. All routers are running RIPv1. What changes will occur in the routing table of router B if a loopback interface with an address of 10.16.1.129/27 is configured on router B?
Routes to the 10.16.1.0/27, 10.16.1.64/27, and 10.16.1.128/27 networks are added.
A connected route to the 10.16.1.128/27 network is added.
A third route to the 10.0.0.0/8 network with RIPv1 as the source is added.
The 10.0.0.0/8 route is dropped immediately from the routing table after router B is configured.
Popular Posts
-
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
-
10.0.0.0/8 127.0.0.0/8 169.254.0.0/16 172.16.0.0/12 192.168.0.0/16 209.165.201.0/27
-
port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware Power over Ethernet (PoE)
-
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur...
-
reduced routing table size dynamic address assignment automatic route redistribution reduced routing update traffic automatic summariza...
-
Refer to the exhibit. Which summarization should R1 use to advertise its networks to R2? 192.168.1.0/24 192.168.0.0/24 192.168.0.0/22...
-
direct configuration of the device cable color code association cable selection and configuration use of cable testers to determine pino...
-
recognizes streams of bits identifies the network layer protocol makes the connection with the upper layers identifies the source and des...
-
Refer to the exhibit. Routers 1 and 2 are directly connected over a serial link. Pings are failing between the two routers. What change b...
-
increased security reduced effort in configuring routes the administrator maintains control over routing easier to implement in a growin...