cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. The exhibited network contains a mixture of Cisco and non-Cisco routers. The command debug ip rip was entered on the JAX router. All routers are running the same version of RIP. Router CHI and Router ORL are not able to reach the 192.168.1.16/28 network. What is a possible solution to this problem?
Enable split horizon in the network.
Configure RIPv2 on routers.
Add network 192.168.1.0 to the RIP configuration on the JAX router.
Configure JAX Fa0/0 as a passive interface.
Enable the Serial0/0/0 interface on the JAX router.
Change the IP address on the Fa0/0 interface of the JAX router to 192.168.1.1/24.
Popular Posts
-
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
-
direct configuration of the device cable color code association cable selection and configuration use of cable testers to determine pino...
-
Refer to the exhibit. Routers East and West are configured using RIPv1. Both routers are sending updates about their directly connected ...
-
255.255.255.252 for QA 255.255.255.224 for Sales 255.255.255.240 for QA 255.255.255.248 for QA 255.255.255.0 for Sales
-
Spanning Tree Protocol (STP) Dynamic Trunking Protocol (DTP) Router Information Protocol (RIP)
-
The destination network no longer exists. The destination network is moved to a different interface on the same router. The path between ...
-
uses a broadcast to update all other routers in the network every 60 seconds uses a multicast address to update other routers every 90 sec...
-
Subnet masks will be added to the routing updates. Routing updates will be sent out using multicast address 224.0.0.9. Version 1 and 2 up...
-
ping ifconfig show vlan traceroute
-
when the interface is functioning as a DTE device when the interface timers have been cleared when the connected DTE device is shut down ...
