cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. R1 is configured properly for a single area OSPF, and R2 has been recently installed in the network. Which set of commands is required to configure a single area OSPF for the networks that are connected to R2?
R2(config)# router ospf 1
R2(config-router)# network 192.168.2.0 0.0.0.255 area 0
R2(config-router)# network 10.1.1.0 0.0.0.3 area 0
R2(config)# router ospf 1
R2(config-router)# network 192.168.2.0 0.0.0.255 area 0
R2(config)# router ospf 2
R2(config-router)# network 10.1.1.0 0.0.0.3 area 0
R2(config)# router ospf 1
R2(config-router)# network 192.168.2.0 0.0.0.255 area 0
R2(config-router)# network 10.1.1.0 0.0.0.3 area 1
R2(config)# router ospf 1
R2(config-router)# network 192.168.2.0 0.0.0.255 area 0
R2(config-router)# network 10.0.0.0 0.0.0.3 area 1
Popular Posts
-
192.168.256.1 172.125.222.10 10.0.0.254 192.168.10 255.255.255.255
-
HDLC PPP ATM WAP MPLS
-
convergence redundant links link aggregation network diameter
-
EIGRP OSPF RIP IS-IS BGP
-
HA DRS FT Storage DRS
-
Layer 1 Layer 2 Layer 3 Layer 4
-
RIPv2 EIGRP OSPF IS-IS
-
Physical Layer Data Link Layer Network Layer Application Layer