cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. A network technician enters the static route in R1 needed to reach network 10.1.1.0/24. A ping from R1 to Host B fails. The technician begins testing the network and has the following results:
Refer to the exhibit. A network technician enters the static route in R1 needed to reach network 10.1.1.0/24. A ping from R1 to Host B fails. The technician begins testing the network and has the following results:
1. pings from R1 to the S0/0/0 interface on R2….successful
2. pings from R1 to the Fa0/0 interface on R2….successful
3. pings from Host B to hosts on the 10.1.1.0/24 network….successful
4. pings from Host B to the Fa0/0 interface on R2….successful
5. pings from R2 to Host B….successful
23. What is the likely cause of the failure of the ping from R1 to Host B?
Host B has a defective Ethernet card.
The default gateway on Host B is not correctly set.
There is a Layer 2 problem between R2 and Host B.
R2 does not have routes back to networks connected to R1.
Popular Posts
-
Refer to the exhibit. The Ethernet interface on Router2 goes down and the administrator notices that the route is still valid in the rout...
-
MDA IMAP MTA POP SMTP MUA
-
straight-through rollover cross-over serial
-
The router will install the first route it learned into the routing table. The router will install both routes in the routing table and lo...
-
A host uses a default route to transfer data to another host on the same network segment. A host uses a default route to forward data to the...
-
It indicates that there are 8 hops between this router and the 10.0.0.0 network. It represents the time, in milliseconds, it takes for ...
-
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
-
centralized administration does not require specialized software security is easier to enforce lower cost implementation ...
-
Keep the existing static route and configure a new static route with the correct next hop IP address. Negate the existing static route and ...
-
192.168.4.63 /26 192.168.4.129 /26 192.168.4.191 /26 192.168.4.51 /27 192.168.4.95 /27
