Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which three interior routing protocols support VLSM? (Choose three.)
OSPF
RIP v1
RIP v2
EIGRP
BGP
STP
ccna exploration 2 chapter 6 Exam Question And Answers
Which three interior routing protocols support VLSM? (Choose three.)
Newer Post
Older Post
Home
Popular Posts
A network administrator has been told that the company IP address infrastructure must adhere to RFC 1918. What three IP address ranges from RFC 1918 could the administrator use on the network? (Choose three.)
10.0.0.0/8 127.0.0.0/8 169.254.0.0/16 172.16.0.0/12 192.168.0.0/16 209.165.201.0/27
What is a primary role of the Physical layer in transmitting data on the network?
create the signals that represent the bits in each frame on to the media provide physical addressing to the devices determine the path ...
A network administrator is selecting a switch that will operate at the network core. Which three features should the switch support for optimum network performance and reliability? (Choose three.)
port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware Power over Ethernet (PoE)
Best Books for Cisco Ccna Exam preparation
Cisco CCNA Routing and Switching 200-120 Official Cert Guide Library By Wendell Odom Pages: 1600 Publisher Cisco Press Cisco CCNA R...
In most business LANs, which connector is used with twisted-pair networking cable?
BNC RJ-11 RJ-45 Type F
What is the likely impact of moving a conventional company architecture to a completely converged network?
Local analog phone service can be completely outsourced to cost-effective providers. The Ethernet VLAN structure is less complex. A shared i...
In a packet-switched data network, what is used to reassemble the packets in the correct order at the destination device?
source address sequence number priority assignment destination address
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on each router:
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac...
What are three functions of the upper data link sublayer in the OSI model? (Choose three.)
recognizes streams of bits identifies the network layer protocol makes the connection with the upper layers identifies the source and des...
Refer to the exhibit. Routers 1 and 2 are directly connected over a serial link. Pings are failing between the two routers. What change by the administrator will correct the problem?
Refer to the exhibit. Routers 1 and 2 are directly connected over a serial link. Pings are failing between the two routers. What change b...