Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
XYZ Company is installing new cable runs on their data network. What two types of cable would most commonly be used for new runs? (Choose two.)
coax
Cat4 UTP
Cat5 UTP
Cat6 UTP
STP
ccna exploration 1 chapter 8 Exam Question And Answers
XYZ Company is installing new cable runs on their data network. What two types of cable would most commonly be used for new runs? (Choose two.)
Newer Post
Older Post
Home
Popular Posts
What information is added during encapsulation at OSI Layer 3?
source and destination MAC source and destination application protocol source and destination port number source and destination IP a...
What are two characteristics of peer-to-peer networks? (Choose two.)
scalable one way data flow decentralized resources centralized user accounts resource sharing without a dedicated server
Refer to the exhibit. Which type of network design is shown?
client/server wide area dedicated server peer-to-peer
A network administrator is required to use media in the network that can run up to 100 meters in cable length without using repeaters. The chosen media must be inexpensive and easily installed. The installation will be in a pre-existing building with limited cabling space. Which type of media would best meet these requirements?
STP UTP coaxial single-mode fiber multimode fiber
Which subnet mask would be assigned to the network address of 192.168.32.0 to provide 254 useable host addresses per subnetwork?
255.255.0.0 255.255.255.0 255.255.254.0 255.255.248.0
Refer to the exhibit. A ping between host A and host B is successful, but pings from host A to operational hosts on the Internet fail. What is the reason for this problem?
Refer to the exhibit. A ping between host A and host B is successful, but pings from host A to operational hosts on the Internet fail. Wha...
An additional subnet is required for a new Ethernet link between Router1 and Router2 as shown in the diagram. Which of the following subnet addresses can be configured in this network to provide a maximum of 14 useable addresses for this link while wasting the fewest addresses?
An additional subnet is required for a new Ethernet link between Router1 and Router2 as shown in the diagram. Which of the following su...
During the encapsulation process, what occurs at the data link layer?
address is added. The logical address is added. The physical address is added. The process port number is added.
Two routers need to be configured within a single OSPF area. Which two components need to be configured on both routers to achieve this? (Choose two.)
the same process ID the same area ID network addresses and wildcard masks the same router ID the same loop back address
Refer to the exhibit. If RIP is the routing protocol, what is the value of the metric from router A to network 192.168.5.0/24?
Refer to the exhibit. If RIP is the routing protocol, what is the value of the metric from router A to network 192.168.5.0/24?