RIP is a link-state routing protocol.
RIP uses only one metric—hop count— for path selection.
Advertised routes with hop counts greater than 10 are unreachable.
Messages are broadcast every 10 seconds.
Popular Posts
-
Refer to the exhibit. What two pieces of information can be determined from the output that is shown? (Choose two.) The local host is... -
port security security policies 10 Gigabit Ethernet quality of service (QoS) hot-swappable hardware Power over Ethernet (PoE)
-
reduced routing table size dynamic address assignment automatic route redistribution reduced routing update traffic automatic summariza...
-
physical, network, application, data link, presentation, session, transport application, physical, session, transport, network, data link...
-
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur... -
Refer to the exhibit. The interfaces of all routers are configured for OSPF area 0. R3 can ping R1, but the two routers are unable to esta... -
increased security reduced effort in configuring routes the administrator maintains control over routing easier to implement in a growin...
-
provides the formatting of data provides end-to-end delivery of data between hosts provides delivery of data between two applications pr...
-
direct configuration of the device cable color code association cable selection and configuration use of cable testers to determine pino...
-
R1 will drop the packet because R1 does not have a specific route in its routing table to the 10.1.1.0/24 network. R1 will forward the p...