cisco certification 200-125 ccna exam preparation with practice questions and Answers
Refer to the exhibit. A network administrator wants to reduce the size of the routing table of R1. Which partial routing table entry in R1 represents the route summary for R2, without including any additional subnets?
10.0.0.0/16 is subnetted, 1 subnets
D 10.5.0.0[90/205891] via 192.168.1.2, S0/0/0
10.0.0.0/24 is subnetted, 4 subnets
D 10.5.0.0[90/205198] via 192.168.1.2, S0/0/0
10.0.0.0/22 is subnetted, 1 subnets
D 10.5.0.0[90/205901] via 192.168.1.2, S0/0/0
10.0.0.0/8 is subnetted, 4 subnets
D 10.5.0.0[90/205001] via 192.168.1.2, S0/0/0
Popular Posts
-
Configure the router ID on both routers. Configure the R2 router interfaces for area 0. Configure a loopback interface on both rout...
-
It is the value assigned by the Dijkstra algorithm that designates the number of hops in the network. It is the value used by the DUA...
-
Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technici...
-
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2?
-
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol...
-
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac...
-
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur...
-
R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.1.1.0 0.0.0.3 area 0 ...
-
Refer to the exhibit. The interfaces of all routers are configured for OSPF area 0. R3 can ping R1, but the two routers are unable to esta...
