R001 : VMware HA must be functional.
R002 : VMware SRM can be used between two sites for DR processes.
R003 : You must be able to see all hosts from a single pane of glass.
From these requirements :
A vSphere 5.0 VCSA can provides an acceptable solution.
A vSphere 5.0 Windows-based vCenter can provide an acceptable
The requirements cannot be met.
Explanation :
The VCSA can function with VMware SRM. However, for SRM functionality, both sites require a vCenter installation. This would limit the choice of single-glass-pane management to Linked mode. A Linked mode installation requires Microsoft technology in the ADAM instance, and thus eliminates the VCSA choice.
Popular Posts
-
Configure the router ID on both routers. Configure the R2 router interfaces for area 0. Configure a loopback interface on both rout... -
It is the value assigned by the Dijkstra algorithm that designates the number of hops in the network. It is the value used by the DUA... -
Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technici... -
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2? -
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol... -
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac... -
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur... -
R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.1.1.0 0.0.0.3 area 0 ... -
Refer to the exhibit. The interfaces of all routers are configured for OSPF area 0. R3 can ping R1, but the two routers are unable to esta...
