IP 172.16.0.18, subnet mask 255.255.255.0
IP 172.16.32.15, subnet mask 255.255.255.240
IP 172.16.0.18, subnet mask 255.255.255.252
IP 172.16.32.18, subnet mask 255.255.255.252
Refer to the exhibit. Which combination of IP address and subnet mask can be used on the serial interface of Router2 in order to put the interface in the same network as the serial interface of Router1?
IP 172.16.0.18, subnet mask 255.255.255.0
IP 172.16.32.15, subnet mask 255.255.255.240
IP 172.16.0.18, subnet mask 255.255.255.252
IP 172.16.32.18, subnet mask 255.255.255.252
Popular Posts
-
Configure the router ID on both routers. Configure the R2 router interfaces for area 0. Configure a loopback interface on both rout... -
It is the value assigned by the Dijkstra algorithm that designates the number of hops in the network. It is the value used by the DUA... -
Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technici... -
Refer to the exhibit. What destination IP address will PC1 place in the header for a packet destined for PC2? -
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol... -
Refer to the exhibit. RIPv1 is configured as the routing protocol for the network that is shown. The following commands are used on eac... -
The IP address of host A is incorrect. The default gateway of host A is incorrect. The Fa0/1 interfaces of the two routers are configur... -
R2(config)# router ospf 1 R2(config-router)# network 192.168.2.0 0.0.0.255 area 0 R2(config-router)# network 10.1.1.0 0.0.0.3 area 0 ... -
Refer to the exhibit. The interfaces of all routers are configured for OSPF area 0. R3 can ping R1, but the two routers are unable to esta...
