Refer to the exhibit. Router1 and Router2 are running the RIPv1 protocol. The network administrator configures the command network 10.1.0.0 on Router1. What network will Router1 advertise to Router2?
10.1.0.0/1610.1.0.0/8
10.0.0.0/16
10.0.0.0/8
Popular Posts
-
VTY interface console interface Ethernet interface secret EXEC mode privileged EXEC mode router configuration mode
-
Load balancing occurs when a router sends the same packet to different destination networks. Load balancing occurs when a router sends the...
-
source end transfer intermediary -
Refer to the exhibit. A technician needs to add a new loopback interface to test routing functionality and network design. The technici... -
If RouterC receives a packet that is destined for 10.5.1.1, it will be forwarded out interface Fa0/0. If RouterA receives a packet that is...
-
Refer to the exhibit. An administrator is attempting to configure a router by copying and pasting the commands that are shown in the ex... -
OSPF use Hop Count as Metric it supports VLSM Area 0 is Called Backbone Area Process id has to be match in all routers
-
decapsulates the Layer 3 packet by stripping off the Layer 2 frame header uses the destination MAC Address in the IP Header to look up the ...
