CDP running on Router D will gather information about routers A, B, C, and E.
By default, Router A will receive CDP advertisements
from routers B and C.
If routers D and E are running different routing protocols, they will not
exchange CDP information.
Router E can use CDP to identify the IOS running on Router B.
Popular Posts
-
Administrative distance refers to the trustworthiness of a particular route. A router first installs routes with higher administrative dis...
-
POST code the routing table the running-configuration the start-up configuration the bootstrap instructions a copy of the operating sys...
-
the network requires a special hierarchical design fast convergence of the network is crucial the network is using a hub and spoke topolo...
-
Refer to the exhibit. Routers R1 and R2 are directly connected via their serial interfaces and are both running the EIGRP routing protocol... -
clears an unreachable route from the routing table after the invalid timer expires prevents regular update messages from inappropriately ...
-
Load balancing occurs when a router sends the same packet to different destination networks. Load balancing occurs when a router sends the...
-
addressing error detection frame delimiting port identification path determination IP address resolution
-
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
-
RIP is a link-state routing protocol. RIP uses only one metric—hop count— for path selection. Advertised routes with hop counts greater t...
