Cisco Ccna Exam Questions
cisco certification 200-125 ccna exam preparation with practice questions and Answers
Which prompt is used to allow a user to change the IP address of an interface on a router?
Router>
Router#
Router(config)#
Router(config-if)#
ccna 2 final Exam Question And Answers
Which prompt is used to allow a user to change the IP address of an interface on a router?
Newer Post
Older Post
Home
Popular Posts
What is the likely impact of moving a conventional company architecture to a completely converged network?
Local analog phone service can be completely outsourced to cost-effective providers. The Ethernet VLAN structure is less complex. A shared i...
You have been asked to design a system with following VMware functionality enabled
R001 : VMware HA must be functional. R002 : VMware SRM can be used between two sites for DR processes. R003 : You must be able to see all ...
Refer to the exhibit. A network administrator is troubleshooting a connectivity problem and needs to determine the address that is used to forward network packets out the network. Using the netstat -r command, the administrator would identify which address as the address to which all hosts send packets that are destined for an outside network?
Refer to the exhibit. A network administrator is troubleshooting a connectivity problem and needs to determine the address that is used...
The following line of code is displayed in a routing table: R 209.165.201.0/24 [120/2] via 192.168.252.2, 00:00:16, S0/0/0 What can be concluded from this output?
A packet destined for host 192.168.252.2 will be forwarded out the interface connected to network 209.165.201.0/24. The value, 120, is use...
ccna exploration 1 chapter 4 exam answers
Refer to the exhibit. What two pieces of information can be determined from the output that is shown? (Choose two.) The local host is...
Refer to the exhibit. What subnet mask will be applied if Router A sends a RIPv1 update for the network 172.16.1.0 to Router B?
Refer to the exhibit. What subnet mask will be applied if Router A sends a RIPv1 update for the network 172.16.1.0 to Router B?
A router learns two paths with equal metrics to a destination network via the RIP routing protocol. How will the router handle packets to the destination network?
The router will install the first route it learned into the routing table. The router will install both routes in the routing table and lo...
What does a router running RIP do first with a new route that is received from an advertisement?
places it immediately in the routing table adjusts the metric for the new route to show the added distance for the route advertises this...
Refer to the exhibit. The number of required host addresses for each subnet in a network is listed in the exhibit. This number includes the host address requirements for all router ports and hosts on that subnet. After all device and router port address assignments are determined, what will be the total number of unused host addresses available?
Refer to the exhibit. The number of required host addresses for each subnet in a network is listed in the exhibit. This number include...
Refer to the exhibit. The frame shown in the exhibit was received by the router. The router interfaces are operational. How will the router process this frame? (Choose two.)
The router will change the source and destination IP address in the packet before forwarding the frame. The router will change the fram...